Figure 3a also shows that different film thicknesses require different dye adsorption times to achieve their respective GSK690693 peak J SC values. The dye adsorption

time required to achieve the maximum J SC value increased from 1 h for the 20-μm photoelectrode to Tozasertib approximately 3 h for the 31-μm photoelectrode. The 26-μm photoelectrode achieved the highest J SC. Figure 3 Dependence of photovoltaic parameters of fabricated cells on dye adsorption time and ZnO film thickness. (a) J SC, (b) V OC, (c) FF, and (d) conversion efficiency. Figure 3b presents a comparison of V OC values of the fabricated devices. This figure shows that the V OC values first increase with the dye adsorption time. After reaching a maximum V OC value, a further increase in the adsorption time leads to a decline in the V OC value. Similar to the J SC plot, the adsorption time required to achieve the respective maximum V OC increases as the film thickness increases. Figure 3b also shows that the maximum V OC values decrease slightly Selleck Milciclib as the film thickness increases. This is likely the result of increased charge recombination and more restricted mass transfer with thick films. As the film thickness increases, electrons encounter a longer transport distance and recombine more easily with I3 −. This results in a stronger electron transfer resistance and a shorter electron lifetime in the ZnO film [31]. The FF values shown in Figure 3c exhibit no clear

trends. The FF values vary between 0.67 and 0.72, which are relatively high compared to those reported for ZnO-based DSSCs [37, 41]. Based on these parameters, the overall conversion efficiencies at various Farnesyltransferase dye adsorption times and film thicknesses were calculated. The efficiency plot (Figure 3d) closely resembles the J SC plot (Figure 3a). Their trends are similar and their peak values appear at the

same dye adsorption times. J SC is the efficiency-determining parameter because the dye adsorption time has a considerably stronger effect on J SC than on other photovoltaic parameters. Figure 3d also shows that each film thickness has a unique optimal dye adsorption time at which the maximum conversion efficiency occurs. The optimal dye adsorption time determined at a given film thickness does not apply to other thicknesses. This is because the dye adsorption time is either too short or too long for other film thicknesses, resulting in considerably lower efficiencies. For example, when a dye adsorption time of 3 h (optimal for the 31-μm film) was applied to the 20-μm film, the conversion efficiency dropped from the peak value of 4.95% to approximately 3.4%, representing a 31% drop. Prolonged dye adsorption times cause dye aggregation [32, 35–38] and etching of the ZnO surface [39], both of which result in performance deterioration in ZnO-based DSSCs. Conversely, TiO2-based DSSCs are typically less sensitive to prolonged sensitization times because of the higher chemical stability of TiO2[32–34]. For example, Lee et al.